sh ver (show wersion)

Restoring to factory default

conf t > config factory-default (if you reload here it leaves old u/p data)

write mem

conf t > write erase

reload

Backup using tftp server

- setup your tftp server, learn the IP and directory, port 69 needs to be open on your fw

en > write net [x.x.x.x]:asa_backup (, [x.x.x.x] - your tftp server IP and asa-backup - custom file name for the backup text file)

Restoring conf:

copy tftp start

1. Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point.
2. Press and hold the MODE button while you reconnect power to the access point.
3. Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button. All access point settings return to factory defaults.

The following configuration has been applied to Cisco Aironet 1140 Series AIR-AP1142N-A-K9 802.11a/g/n

After connecting Cisco power injector to Arionet 1130AG access point apparently does not work until you run two commands:

no power inline negotiation prestandard source
power inline negotiation injector installed

It sems like CDP discovers the injector but it needs to have properly configured port (proper MAC address).

Problem:

    Windows 8
    Cisco VPN client 64-bit
    you install and configure everything correctly and suddenly after typing credentials error appears:

Reason 442: Failed to enable virtual adapter

And here is the reason, there is a wrong registry value created during the installation of your client. Who knows why? The incorrect registry key contains invalid DisplayName:

@oem4.inf,%CVirtA_Desc%;Cisco Systems VPN Adapter for 64-bit Windows

You should have: Cisco Systems VPN Adapter for 64-bit Windows